Veneer Finger Joint

Veneer Finger Joint

The wood veneer finger joint connects two pieces of wood veneer through non-woven fabric. The gap at the junction of the wood veneer is finger-jointed.

Inquiry Contact

Technical parameters

Model	RD300A
Wood veneer connection method	Finger Jointing
Working width	45-300mm
Working thickness	0.3-0.6mm
Working length	Infinite length
Table height	900mm
Connection temperature	120℃-240℃
Power	3.5kw

Video

Characteristic

The veneer finger joint is a composite material formed by joining wood veneers of the same specification through finger-shaped splicing technology. Achieve unlimited length extension.

The advantage of veneer finger joint is its strong resistance to deformation and resistance to shrinkage and expansion caused by temperature and humidity changes.

You may also be concerned about

The reasons for the deviation of the abrasive belt

The normal swing amplitude and frequency of the abrasive belt have their standard range. If not adjusted properly, the abrasive belt may operate in an abnormal state, causing it to deviate.
Adjustment methods for abrasive belt deviatio

Check and adjust the swing amplitude and frequency of the abrasive belt to ensure they are within the normal range (usually the swing amplitude is 15-20mm and the swing frequency is 15-20 times per minute).
Maintenance and repair of Wide Belt Sander

1.Regularly inspect and replace worn abrasive belts and contact rollers to ensure the sanding effect and processing accuracy.
2. Conduct a thorough cleaning of the equipment, especially regularly removing wood chips and dust from the surface of the sand belt and rollers.
Flow rate adjustment of the spray gun

The power source of the spray gun is controlled by the compressed air pressure valve. The pressure value directly affects the atomization effect of the spray. The working pressure range is 0.3-0.5Mpa.
Cleaning after using the spray painting machine

Pour the cleaning agent into the feeding port of the paint spraying machine, start the paint spraying machine, and let the cleaning agent circulate in the pipeline to clean the paint and dirt inside the pipeline. This process can last for several minutes until the cleaning agent is discharged clearly.