50T Hydraulic Cold Press

50T Hydraulic Cold Press

The cold press is a device that processes and forms at normal temperature. Pressurization is generally achieved through hydraulic transmission. The cold Press adopts an integrated oil cylinder,which can protect against oil leakage for long time use, and can achieve a good pressure holding effect.

Inquiry Contact

Technical parameters

Model	MYJ50T
Max. pressure	50T
Dimension of the platen	1250x2500mm
Working speed	180mm/min
Total power	3Kw
Serve Opening	1000mm
Cylinder Number	2
Cylinder Diameter	Φ110-70mm
Net weight	2800Kg

Video

Characteristic

The cold press is a device that processes and forms at normal temperature. Pressurization is generally achieved through hydraulic transmission.

The cold Press adopts an integrated oil cylinder,which can protect against oil leakage for long time use, and can achieve a good pressure holding effect.

The lower table structure of cold press adopts crisscross welding to make the pressure distribution of the whole table uniform,protect the flatness of the pressing surface for a long time ,and improve the quality of processed products.

You may also be concerned about

The reasons for the deviation of the abrasive belt

The normal swing amplitude and frequency of the abrasive belt have their standard range. If not adjusted properly, the abrasive belt may operate in an abnormal state, causing it to deviate.
Adjustment methods for abrasive belt deviatio

Check and adjust the swing amplitude and frequency of the abrasive belt to ensure they are within the normal range (usually the swing amplitude is 15-20mm and the swing frequency is 15-20 times per minute).
Maintenance and repair of Wide Belt Sander

1.Regularly inspect and replace worn abrasive belts and contact rollers to ensure the sanding effect and processing accuracy.
2. Conduct a thorough cleaning of the equipment, especially regularly removing wood chips and dust from the surface of the sand belt and rollers.
Flow rate adjustment of the spray gun

The power source of the spray gun is controlled by the compressed air pressure valve. The pressure value directly affects the atomization effect of the spray. The working pressure range is 0.3-0.5Mpa.
Cleaning after using the spray painting machine

Pour the cleaning agent into the feeding port of the paint spraying machine, start the paint spraying machine, and let the cleaning agent circulate in the pipeline to clean the paint and dirt inside the pipeline. This process can last for several minutes until the cleaning agent is discharged clearly.